ABUIABACGAAg_bbQ6AUo4aWL9AYwrAI4qwI

Wuxi Zhongheng Gas Equipment Co., Ltd.

Telephone Fax: 0510-83318825

Manager Chen: 19895736663

Manager Chen: 13395192958

Manager Liu: 13395131570

Address: No. 8 Huanzhen South Road, Yangshi City, Luoshui Town, Wuxi

Online Service
 Work Time
Mon to Fri :8:30-17:30
Sat to Sun :9:00-17:00
 Contact Details
address:No. 8 Huanzhen South Road, Yangshi City, Luoshui Town
mailbox:974220849qq.com
相关文章推荐
文章附图

Today, I want to share with you the use of PSA nitrogen m...

文章附图

PSA nitrogen machine is a new gas separation technology. ...

文章附图

Nitrogen generator is an advanced gas separation technolo...

Product Detail
50 cubic meters nitrogen machine
Share to:

50 cubic meters nitrogen machine

product details

制氮50.jpg

产品介绍.jpg


Product introduction:

The air is compressed by a compressor and then dried in a freeze dryer to meet the dew point requirement of the raw air in the pressure swing adsorption nitrogen production system. The oil and water in the raw air are removed by filters and then entered into the air buffer tank to reduce pressure fluctuation. It is sent to the nitrogen machine (with carbon molecular sieve inside), where air is separated to produce nitrogen. Raw material air enters one of the adsorbers to produce nitrogen, while the other one is regenerated by decompression desorption. Two adsorbers work alternately, continuously supplying raw air and continuously producing nitrogen. Nitrogen is sent to the nitrogen buffer tank, and the pressure is adjusted to the rated pressure by the pressure regulating valve. Then it is measured by flowmeter and analyzed by nitrogen analyzer. The qualified nitrogen is reserved and the unqualified nitrogen is emptied.

Product advantages:

1. Considering the technical level and economy of nitrogen production, this scheme uses pressure swing adsorption (PSA) to produce nitrogen, and uses high performance carbon molecular sieve from Takeda, Japan, to separate nitrogen with purity (>99.999%) from compressed air. The equipment is simple in composition, occupies less space, is easy to operate and maintain, and has a low failure rate. And the energy consumption is low, and the operation cost of the equipment is low.

2. In order to ensure the long term, stable and normal operation of the PSA nitrogen making machine, the compressed air must be cleaned up before entering the nitrogen making machine, such as dust, water and oil removal, in order to meet the requirements of the nitrogen making machine for compressed air quality. Therefore, in the selection of cold driers and filters, we choose well known domestic brands to ensure the stable and long term operation of the whole system.

3. In order to ensure the long term and reliable operation of the whole nitrogen system, the main components of PSA nitrogen machine, such as molecular sieves, valves and controllers, are imported from the original well known brand products. To ensure the quality and safety of equipment, long term and reliable operation of the whole system.

4. Pressure swing adsorption (PSA) is characterized by a certain relationship between nitrogen flow rate and purity. The higher the flow rate used, the lower the purity of nitrogen; the lower the flow rate used, the higher the purity of nitrogen. Users can adjust the flow and purity appropriately according to the usage.

5. The operation of the equipment is controlled by PLC. The equipment runs automatically and produces qualified nitrogen gas. The equipment is easy to operate and can be unattended.


产品特点.jpg


Seven characteristics:

1. Simple operation 2. Easy to use 3. Economical and applicable 4. Low energy consumption 5. High efficiency 6. Safety and stability 7. Wide application


维护注意.jpg


1. Normal supply of power supply, gas source and temperature conditions required by the machine and normal opening and closing; especially the stability of power supply voltage, nitrogen machine, reduce the damage to the controller and solenoid valve caused by power supply problems.

2. Always pay attention to the pressure of the air storage tank. Keep the pressure of the air storage tank between 0.7 MPA and 0.75 MPA. Do not lower than the rated value.

3. Check the automatic drain every day to avoid blocking and losing drainage function. If blocked, slightly open the manual valve, close the self draining valve and remove the automatic drain, decomposition and cleaning. When cleaning the automatic drain, soap foam can be used to clean it. Strictly prohibit the use of gasoline, toluene, pine perfume and other corrosive solutions.

4. Operators should regularly inspect the three pressure gauges on the machine, make a daily record of their pressure changes for equipment failure analysis, and observe the flow meter and nitrogen purity at any time, so as to maintain the nitrogen purity of the exhaust gas.

5. Operate and maintain the instrument according to the requirements of the code of use. Check the sensitivity of solenoid valve/pneumatic valve, the pressure range of pressure regulating valve, the precision of gas analyzer, the pressure of adsorption culture, the exhaust condition of muffler, the cleanliness of inner tube of flowmeter, etc. from time to time.


应用行业.jpg


Widely used in non ferrous metal heat treatment, chemical industry, rubber industry, pharmaceutical industry, food industry, metallurgical industry, electronic industry, glass industry, coal industry, aerospace technology support, petroleum industry, plastics industry, textile industry and other industries and fields.




Other articles recommended
文章附图

Nitrogen making machine is a nitrogen generating equipmen...

文章附图

What are the technical design features of nitrogen machin...

文章附图

What are the applications of nitrogen machine system in v...

文章附图

Nitrogen making machine is a nitrogen generating equipmen...

文章附图

Oxygen generator is a kind of machine which produces oxyg...

文章附图

Today Xiaobian will share with you the technical characte...

文章附图

What is the operating method of the oxygen generator? Her...

Customer Name: Ore Optoelectronics
Products purchased: 300 cubic meters nitrogen machine Customer evaluation: Zhongheng is very professional, delivery is very fast, after-sales is also very good, next time there is demand will continue to cooperate with them!
Customer Name: Huazhong Glass
Products purchased: 100 cubic meters of oxygen generator
Customer comments: excellent products, quality no problem......
Customer Name: Really Old
Products purchased: 20 cubic meters nitrogen machine
Customer evaluation: There is no problem with the quality......
Customer Name: Abram Magnesium Carbon Industry
Products purchased: 180 cubic meters nitrogen machine
Customer evaluation: The product......
Wuxi Zhongheng is a specialized manufacturer of gas separation equipment. It has advanced technical advantages in the nitrogen machine industry. Because of its focus, it is professional. With advanced science and technology, high quality and efficient service, it enjoys a good reputation in the industry and high-tech entities in many fields.
Our company has many years of research and development, production experience and customer experience in various types of gas air separation equipment. In line with the tenet of "scientific and technological innovation, pursuit of excellence, honest management", the company provides satisfactory products for the vast number of users.
The company's stable operation of equipment, superior performance, reliable after-sales service, won the unanimous praise of the majority of customers. Excellent staff team, advanced processing equipment, strict quality assurance system, perfect sales network, give full confidence in the future, but also give customers great confidence guarantee, let us work together to create a better tomorrow.
What is the operating method of the oxygen generator? Here is a short edition to share with you. The main engine is mounted on wheels ......
The special nitrogen machine for petroleum and natural gas industry is suitable for mainland oil and natural gas exploitation, coastal and deep-sea oil and...